Wilderness Tent Angle Joint Kits & Angles - 120º Peak & Eaves
WILDERNESS ANGLES ARE 120 DEGREES.
PROVIDE B & C TENT MEASUREMENTS IF YOU ARE NOT POSITIVE ANGLES REQUIRED ARE 120 DEGREES.
If your provided angle measurements are not 120 degrees you will be required to pay for custom angles.
Click angle kits for instructions on how to measure tent for B & C measurements.
We will calculate your degree of angles based on your tent measurements. Shipping angles to and from customer will not be reimbursed if you order the wrong angles or provide inaccurate tent measurements.
Wilderness tent angle joint kits can ship 3-5 DAYS after ordering. Most 12', 14', 15', 16' & 18' wide tents require the 120º angle joints.
Strongly recommend you read Tent Frame Information and Recommendations before building your frame or setting up your tent.
Wilderness tent frame angle kit will have a 4-way angle at the front ridge, upon request, to allow you to extend a pipe for an awning. If 4-way on front ridge is not requested, a normal 3-way angle will be provided.
Wilderness angles are galvanized with support braces for additional strength & durability.
Purchasing angle kits and then purchasing 1” inside diameter, thin walled, electrical conduit at a local hardware store is the most economical approach to purchasing an internal frame. Internal frame shipping charges are very high due to the weight of an internal frame. Typical frame savings using an angle kit on a 12x14 internal frame is $200.
I will provide assistance if you have trouble understanding angle kit instructions
95% of my customers buy an angle kit and make their own frame.
Angle kit frames made of steel galvanized conduit. A maximum distance of 6' is recommended between rafters. More than 6' causes a sag in the roof and significantly reduces snow load carrying capacity.
YOU MIGHT ALSO WANT TO CONSIDER :
Rubber bottom caps. Rubber bottom caps are put on the bottom of your frame legs to protect your sod cloth or floor. Caps also prevent any dirt getting into the bottom of frame legs.
Frame bags. Frame bags are used to store and transport your frame poles. Helps insure all your frame poles are in one place and you have no surprises when you reach your campsite.
10" Sleeves. Sleeves are used when the vehicle you are transporting your frame in is too short for your rafters. Cut the rafters in half and when setting up your frame , the sleeve connects the 2 piece rafters. I recommend gluing the sleeve on the half rafters to insure you don't lose them.
Leg Supports. Primarily used to attach tent frame legs to a platform. Tent frame legs can easily fall off a platform during high winds. Tent platforms normally have a smooth surface compared to the ground and that is why the legs can be moved when there are strong winds.